RS232 cable for connecting syringe pump controller to a computer or other device.
Up to three D Series syringe pumps can be controlled externally with analog voltage for either constant flow or constant pressure.
User-selectable ranges of 0 to 5, 0 to 10, and -5 to 5 V.
Resolution of 5000 increments per volt.
Functions: Run/Stop, flow, or pressure setpoint.
Terminal block connections require one wire for ground and one input wire for each pump.
Analog outputs can be purchased pre-installed in a controller, or as an upgrade kit.
Software -selectable output ranges: 0 to 5 , -5 to +5 , 0 to 10 V
Output functions: flow and volume
Female 25 pin Sub-D connector
This device is internally mounted and outputs signals for flow rate and pressure for one pump, but can be expanded to up to three pumps with additional output modules.
